Passare al contenuto

← Tutti i processi

Atmospheric crude distillation (CDU)

Refinery process

The crude distillation unit heats crude in a furnace and separates it by boiling range in a tall fractionating column. It is the first processing step in almost every refinery and sets the volume of every product that follows.

Carica
Desalted crude oil
Produce
Fuel gas and LPG, Light and heavy naphtha, Kerosene or jet cut, Diesel or gasoil, Atmospheric residue
Temperatura
About 350 to 400 at the furnace outlet
Pressione
Slightly above atmospheric
Catalizzatore
None (physical separation)

Schema di processo

Cosa fa

Crude oil is a mixture of thousands of hydrocarbons with different boiling points. After desalting and preheating, the crude is heated in a fired furnace to about 398 degrees Celsius and fed into a column that runs close to atmospheric pressure. Vapour rises through trays, cooling as it goes, and the lightest fractions leave at the top while heavier fractions are drawn off as side streams lower down. The unvaporised bottom stream, called atmospheric residue, goes on to the vacuum unit. Because the cuts are only separated by boiling point, they still need hydrotreating, reforming or cracking before they become finished fuels.

Passo dopo passo

  1. Desalted crude is preheated against hot product streams
  2. A fired furnace heats the crude to about 398 degrees Celsius
  3. The partly vaporised feed enters the flash zone of the column
  4. Vapour rises through trays and cools; lighter components move up
  5. Overhead vapour is condensed to give gas, LPG and naphtha
  6. Side-draw streams of kerosene and diesel are taken from trays and steam-stripped
  7. Atmospheric residue leaves the bottom for the vacuum unit

La chimica

Separation relies on differences in boiling point, not on chemical change. Light molecules with few carbon atoms boil at low temperatures and rise to the top; heavier molecules with more carbon atoms are less volatile, more viscous and stay lower in the column. Steam injected at the bottom lowers the partial pressure of hydrocarbons so more light material vaporises without raising the temperature to a level that would crack the oil.

Apparecchiature principali

  • Preheat exchanger train
  • Fired heater
  • Atmospheric fractionating column with trays
  • Side strippers
  • Overhead condenser and reflux drum

Sicurezza

Fired heaters and large inventories of hot hydrocarbons create fire and explosion risk; tube failure or water carried into the column can cause sudden releases.

Si metta alla prova

Domanda 1 di 3 · Punteggio 0 · Serie 0

About what temperature is crude heated to before entering the column?

Correlati

Fonti

Redatto con parole proprie di PST a partire dalle fonti sopra. Affidabilità dei dati: high. Gli impianti reali differiscono per progetto e condizioni di esercizio.